← TRACKS 4 TRUCKERS™Our Community Blog
← The Highway Hobo
Equipment & Compliance

Washington Truck Chain-Carry Season Is Underway: Check the Route Before the Pass

Published · TRACKS™ Editorial

The existing November 1–April 1 requirement applies to listed routes and qualifying vehicles. Carrying enough approved chains and installing them under posted controls are separate checks.

A November-to-April seasonal window above separate carry and installation panels.
Original editorial diagram, not a chain-placement drawing. Read the full route list, vehicle requirements and current controls.

An existing seasonal requirement, not a newly passed law

Washington’s seasonal chain-carry window began November 1. WAC 204-24-050 requires vehicles and combinations over 10,000 pounds gross vehicle weight rating to carry sufficient chains on specified routes from November 1 to April 1, or at other times when required. This is an existing rule returning to its seasonal window, not a new 2026 enactment. One listed segment is I-90 between North Bend, milepost 32, and Ellensburg, milepost 101. Consult the full route list rather than assuming every Washington highway has the same seasonal provision.

Carry and install answer different questions

WSDOT explains that chains must be carried during the seasonal window on the listed routes regardless of current road conditions or advisories. Posted chain controls determine when installation is required; the applicable arrangement depends on the vehicle configuration. The WAC also requires at least two extra chains for vehicles over 10,000 pounds GVWR. Do not use a passenger-car exception or a generic tire-chain picture as a truck installation plan. Refer to the current commercial-vehicle guidance and the configuration-specific rule. This article does not replace the official placement diagrams or approve a particular traction device.

Make the equipment check useful

Our pre-trip recommendation is to verify that the carried equipment fits the actual tractor and trailer being used, is accessible and is in serviceable condition. A bag in a compartment is not proof that its contents meet the vehicle’s needs. Resolve missing or questionable equipment with maintenance before committing to the route. Keep the route segment, vehicle configuration and equipment check together in the dispatch notes. If a tractor or trailer changes, review the plan again. This is an editorial workflow suggestion; it does not create an additional statutory inspection form.

Four panels cover route scope, vehicle configuration, equipment and current controls.
Original editorial worksheet. It does not approve a device or replace the official configuration-specific installation requirements.

Check the live control before entering

Review current WSDOT pass information and restrictions before departure and before entering the affected corridor. Carrying chains does not override a closure or establish that the movement can proceed safely. Follow posted controls and agency instructions. If the route or equipment is uncertain, settle the question from a safe stopping location with the responsible carrier personnel. The practical benefit of checking early is that a missing chain or misunderstood control can be addressed before the truck reaches a constrained mountain approach. A clear forecast is not a substitute for the seasonal carry requirement.

Sources & verification

Reporting facts are attributed to the sources above. Practical takeaways and labeled calculations are The Highway Hobo’s analysis. Request a correction.