Camera Monitors Instead of Truck Mirrors? Safety Vision’s FMCSA Request Is Still Pending
FMCSA seeks comments on a View Smart camera-monitor exemption application. December 18 is the comment deadline, not an effective date or permission to remove mirrors.

What FMCSA is considering
FMCSA published Safety Vision’s application November 18. The company seeks an exemption allowing commercial vehicles to use its View Smart camera monitor system as an alternative to the two required rear-vision mirrors. The official agency summary identifies the requested equipment change and explicitly says publication does not indicate whether FMCSA will approve it. This is an application being considered, not a general rule adopting camera-only rear vision for trucks.
December 18 is a comment deadline
The Federal Register notice identifies docket FMCSA-2026-3707 and sets December 18, 2026, as the deadline for comments. Read the official notice and application before responding, and use its submission instructions. A deadline to provide input must not be entered into an equipment file as the date a proposed installation becomes authorized. FMCSA says it will review the application, safety analyses and comments before granting or denying the request.
Separate equipment evaluation from operating authority
Our editorial recommendation for a fleet considering this technology is to keep two questions in separate files: how the proposed system would work in that operation, and what authority would cover the exact installation. For an equipment evaluation, ask about the driver’s view during backing and lane changes, display readability, camera cleaning and how a loss of the image would be handled. These are questions to investigate, not findings that this particular system has a defect or that a future exemption will require a particular procedure.

Make the driver handoff specific
A driver’s practical question is which rear-view equipment is on the actual truck and what instructions apply to it. Ask the responsible fleet personnel to explain any approved configuration, inspection procedure and response to a failed component before the vehicle is assigned. For public comments, describe relevant experience and evidence rather than treating a technology preference as proof of safety. Keep this notice labeled as a pending application when sharing it with maintenance or purchasing staff. Any later decision must be read for its own scope and conditions before making an equipment change.
Sources & verification
- FMCSA: Safety Vision application summary
Checked 2026-11-19 - Federal Register: Safety Vision notice, November 18, 2026
Checked 2026-11-19
Reporting facts are attributed to the sources above. Practical takeaways and labeled calculations are The Highway Hobo’s analysis. Request a correction.